tdw123456
-
all messages by user
25.01.2012 13:55:50
|
Need a special dwg export macro
|
I'm using KC6.5 and if I export from a layout to .dwg and get good repeatable results I have to; burst the layout export to .dwg type a file name escape when back at KC6.5, undo the burst operation to retain associativity
I've tried creating a KXL to do this but it gets stuck after bursting the layout. (see attached KXL file)
Can anyone help me with this?
|
29.01.2012 22:56:14
|
Expotring individual layouts to DWG
|
I've been using Some form of Kubotek since Cadkey 3.1 but I've never been able to figure out how to write a good KXL. I'm currently using KC 6.5, and translation from layout mode to .dwg is never good enough unless I follow the steps listed below; Autoscale the layout burst the layout Export to DWG (ACAD 200) using the preset export options (make the file name of the exported file the same as the Layout title) undo (to reverse the burst operation) end
Can anyone help with this macro?
|
1
|